Desktop Microphone Cantilever Bracket

The room goes quiet, you lean toward the mic, and the arm holds exactly where you left it.

Late evening at the desk, the stream about to start. You pull the boom toward your mouth and it glides in without a single bounce or droop. The spring free internal mechanism means no metal twang, no slow sag halfway through a two hour session, just a steady hold at the angle you set.

The arm is built from aluminum alloy with ABS joints, finished in a clean matte black or white. Its cable channel runs hidden along the length of the arm, so the wire from your microphone disappears from the desk and stays out of the shot. A rubber lined desk clamp bites onto the edge without scratching, and every hinge turns through a full circle.

Key Benefits

• Spring free hold The internal design keeps the boom where you position it without spring tension, so it will not creep or bounce mid recording.
• Hidden cable routing An integrated channel guides the microphone cable along the arm for a clear, uncluttered desk.
• Full range positioning Two pivoting joints and 360 degree rotation let you reach the arm over a keyboard or off to the side.
• Universal clamp The padded desk clamp fits a range of desktop thicknesses and grips without marking the surface.
• Fits standard mics A 5/8 inch mount with an included 3/8 inch adapter matches most studio and streaming microphones.
• Two reach options Choose the standard 50 cm arm or the heightened 60 cm arm for a taller reach.

Best for: streamers, podcasters, home studio vocalists and remote callers who want the microphone in reach and off the desktop.

Why It Works

Most desk arms rely on exposed springs that ping, sag and telegraph every knock through the recording. This one replaces that with a spring free structure and metal joints, so the hold is silent and the position stays put. The clamp base frees the whole desktop surface, and the hidden cable run keeps the microphone wire from creeping into frame.

Quick Product Facts: aluminum alloy and ABS construction; matte black or white; spring free cantilever with two pivots; 360 degree rotation; padded desk clamp; 5/8 inch thread with 3/8 inch adapter; standard arm 50 cm or heightened arm 60 cm; base width 10 cm; microphone not included.

How It Fits Your Routine

Clamp it to the back edge of your desk once and the arm becomes part of the setup. Swing it in when you sit down to record and push it back against the monitor when you are done, leaving the desk clear for a keyboard and mouse.

Thread your microphone onto the 5/8 inch mount, add the 3/8 inch adapter if your mic uses the smaller thread, then tuck the cable into the channel along the arm. The rotation lets you angle the capsule toward your mouth whether you sit high or low.

Wipe the arm down with a dry cloth now and then to keep the finish clean. The clamp loosens by hand when you want to move to a different desk.

FAQ

Is a microphone included? No. The arm holds your own microphone; the mic shown in the images is for scale only.

What thread size does it use? A 5/8 inch mount, with a 3/8 inch adapter in the box so it fits both common microphone threads.

What is the difference between the standard and heightened versions? The standard arm reaches 50 cm and the heightened arm reaches 60 cm; both share the same clamp and joints.

Will the clamp damage my desk? The clamp is rubber lined to grip firmly without scratching, and it fits a range of desktop thicknesses.